Question about parts for Jobo Processors

Thread view:

Enable EMail Alerts

Start New Thread

Thread rating:

HDGarrett@elp.rr.com - 13 Mar 2006 15:10 GMT

I have a Jobo CPA2 processor, which I'd like to use with Expert tanks.
However the lift is fitted with rollers for the smaller-diameter
tanks, so the Expert tanks will work. In other words, I need to
install wider rollers.
My questions:
1. Where can you get replacement parts? I don't see them listed on
the Jobo site.

2. Do I replace the rollers only or the rails-plus-rollers?

Thanks for any advice. Please respond here, rather than with email.

HDG

Reply to this Message

Hans - 13 Mar 2006 20:40 GMT

>I have a Jobo CPA2 processor, which I'd like to use with Expert tanks.
> However the lift is fitted with rollers for the smaller-diameter
[quoted text clipped - 9 lines]
>
> HDG

Hi HDG,
Go to the JOBO site to service , then contact.
Hans

Reply to this Message

Martin Jangowski - 16 Mar 2006 16:25 GMT

> I have a Jobo CPA2 processor, which I'd like to use with Expert tanks.
> However the lift is fitted with rollers for the smaller-diameter
[quoted text clipped - 3 lines]
> 1. Where can you get replacement parts? I don't see them listed on
> the Jobo site.

> 2. Do I replace the rollers only or the rails-plus-rollers?

There is only one type of rollers. The main difference are the holders.
You can install the rollers differently:

holders turned inwards: small tanks (15xx)
holders turned outwards: expert drums (3xxx)
holders removed, rollers installed directly: 25xx tanks

Martin

Reply to this Message